Compatible with all L-TEK pads Including DDR EX PRO and PIU EX PRO
Custom cut Stainless Steel Plate with highly conductive pressure sensitive adhesive backing.
Custom engineered and laser cut stainless steel with electrically conductive adhesive backing. These stainless steel plates are designed to work with all L-TEK pads.
They decrease the distance between the metal sensors creating an ultra-sensitive pad. Backed with industrial strength conductive adhesive infused with silver. Just peel off the sticker like backing to reveal the adhesive, then stick this to the steel sensors on your pad.
These stainless steel inserts increase connectivity and decrease the distance the sensors must travel to register a step on the pad. Easy to install, this mod is meant to be permanent, but it can be removed.
Includes 4 stainless steel plates, once for each arrow panel on the L-TEK pad. A 5 plate version is available for the PIU EX PRO.
Available in two different sensitivity levels
Standard Sensitivity (0.036") - Recommended for the majority of people.
High Sensitivity (0.048") - For those who want a very sensitive pad. Every pad is slightly different based on factors such as manufacturing tolerance and the age of the pad. For this reason the High Sensitivity mod may be too sensitive for some pads. Additional modification may be required to achieve the optimal level of sensitivity.
- 304 Stainless Steel
- Size: 4.5" x 4.5"
- Electrically conductive pressure sensitive adhesive backing
Choose from L-TEK DDR Mod or L-TEK PIU Mod
Comes in 4 pack for the L-TEK DDR pad or 5 pack for L-TEK PIU pads.
Step 1: Unscrews all 4 screws and remove the arrow panel from your L-TEK pad
Step 2: Gently pull up on the top sensor plate to reveal the bottom sensor plate. Be mindful of where the wires are attached to the sensor plate.
Step 3: Clean the sensor plate with rubbing alcohol to remove any dirt and allow to fully dry. This will help ensure that the Steel Plat Sensitive Mod properly adheres to the sensor plate.
Step 4: Remove the sticker like backing on the Steel Plate Sensitivity Mod to reveal the conductive adhesive.
Step 5: Place the Steel Plate Sensitivity Mod on the bottom sensor panel of the L-TEK using the option below that best suits your playstyle.
Option 1: Recommended for most players.
Option 2: Recommended for people who primarily step in the center of the panel when playing.
Step 6: Apply firm pressure to the Steel Plate Sensitivity Mod for approximately 1 minute to ensure a strong hold.
Step 7: Replace the top sensor plate
Step 8: Replace the arrow panel and screws. Be sure to not overtightened the screws.
**Please note that modifying your dance pad in any way may void the manufacturer's warranty**
~If for any reason you are not happy with the part you can get a full refund within 30 days of purchase~