J-PAC JAMMA to PC Adapter
Connect your Dance Dance Revolution Arcade 573 to PC. Used to convert any arcade cabinet using JAMMA to PC. Lets you play StepMania on your DDR arcade machine.
- J-PAC board
- 15-pin cable
- USB cable
The JPAC (JAMMA interface for PC to Arcade Controls) is a board which allows plug-in connection of a JAMMA arcade cabinet to a VGA card and keyboard port or USB port on a PC motherboard. It incorporates all the advanced features of the I-PAC with an on-board JAMMA connector
- Inputs fully protected against static discharge and reverse connection, supports 3 extra JAMMA connections (Tilt, Service SW and Test)
- Supports 12 volt coin doors.
- Fully programmable key code set. Stored even after power off.
- Dual interface USB or Keyboard.
- Supports I-PAC optional pre-assembled LED harness with 3 panel mounting LEDs which emulate the keyboard Lights.
- Lead plugs into keyboard socket on PC or USB port.
- Self-Test LED gives an instant check of all your wiring. Can indicate which, if any, input has a problem.
- No separate power needed.
- Does not use a matrix - no ghost keys. All inputs are completely separate and generate their own interrupt - this is the fastest possible method.
- Does not use a scanning method which causes a variable delay.
- Either uses standard MAME keys or you can program your own character set.
- Shift functions. Holding "Start1" and pressing other buttons sends a range of codes for MAME functions such as "escape", "Coin 1", "tab", "enter". This means no extra buttons are needed on the cabinet. In programmable mode any input can be the shift key and all keys can be programmed with a shifted code.
- Connector for ordinary keyboard which can be used together with the controls if required.
- No special drivers needed. USB drivers are generic Windows.
- All control inputs which are part of a normal JAMMA standard are routed to an on-board JAMMA edge connector.
- Connector for VGA input from PC VGA card. Routes through to JAMMA edge connector for connection to the cabinet arcade monitor.
- On-board video amplifier boosts signal to standard arcade monitor levels. Uses high-bandwidth video amplifier chip.
- Custom microcontroller only allows sync signals to be sent to the monitor if they are in the correct range that the monitor is designed for. Avoids driving the monitor with a too-high horizontal sync rate which can damage some arcade monitors.
- Sync circuitry also converts separate horizontal and vertical syncs into composite sync. Can handle both positive and negative vertical sync.
- If required, can divide a 31Khz VGA signal in half so that it will display a stable picture on a 15Khz arcade monitor. Useful for checking boot-up progress and configuration (not for application use). Automatically stops dividing the signal when it detects a correct 15Khz rate is being send by the PC.
- JAMMA cabinet speaker routed to screw connectors for wiring to powered sound card or hacked PC speakers.
Comparison of J-PAC Control-only version with standard J-PAC.
|Video Passthrough with frequency blocking||YES||NO|
|VGA Cable Supplied||YES||NO|
|Number of buttons per player||8||6|
|Buttons 5 and 6 Support||Screw Terminals||JAMMA Connector (newer cabinets usually are wired this way)|
|Speaker Support||Screw Terminals||To empty header location on board, optional usage.|
~If for any reason you are not happy with the part you can get a full refund within 30 days~