Custom cut Stainless Steel Plate with highly conductive pressure sensitive adhesive backing.
Custom engineered and laser cut stainless steel with electrically conductive adhesive backing. These stainless steel plates are designed to work with all Cobalt Flux pads.
They decrease the distance between the metal sensors creating an ultra-sensitive pad. Backed with industrial strength conductive adhesive infused with silver. Just peel off the sticker like backing to reveal the adhesive. Then stick this to the steel sensors on your pad.
These stainless steel inserts increase connectivity and decrease the distance the sensors must travel to register a step on the pad. Easy to install, this mod is meant to be permanent, but it can be removed.
Includes 4 stainless steel plates, once for each arrow panel on the Cobalt Flux pad. A 5 plate version is available for PIU.
- 4 pack for the DDR style
- 5 pack for PIU style
- 304 Stainless Steel
- Size: 7.5" x 7.5"
- Electrically conductive pressure sensitive adhesive backing
Step 1: Unscrews all 4 screws and remove the arrow panel from your Cobalt Flux pad
Step 2: Gently pull up on the top sensor plate to reveal the bottom sensor plate. Be mindful of where the wires are attached to the sensor plate.
Step 3: Clean the sensor plate with household cleaner to remove any dirt and allow to fully dry. This will help ensure that the Steel Plat Sensitive Mod properly adheres to the sensor plate.
Step 4: Remove the sticker like backing on the Steel Plate Sensitivity Mod to reveal the conductive adhesive.
Step 5: Place the Steel Plate Sensitivity Mod in the center of the bottom sensor plate of Cobalt Flux pad.
Step 6: Apply firm pressure to the Steel Plate Sensitivity Mod for approximately 1 minute to ensure an strong hold.
Step 7: Replace the top sensor plate
Step 8: Replace the arrow panel and screws. Be sure to not overtightened the screws.
~If for any reason you are not happy with the part you can get a full refund within 30 days of purchase~